9
OPERATION (cont.)
Locating a cutting/sanding disc
1. Locate the disc holder in the collet nut (2) .
2. Remove the screw from the end of the disc holder with the 2 in one wrench
provided, and insert the screw through the cutting disc.
3. Replace the screw and cutting disc then tighten the cutting disc onto the holder.
(Do not over-tighten)
Locating a sanding drum
1. Loosen the small screw in the top of the sanding drum holder.
2. This allows the rubber to slacken.
3. Slide the sanding drum onto the holder.
4. Secure the sanding drum in place by tightening the screw causing the rubber drum
to bulge and grip the drum. (Do not over-tighten)
Flexible Shaft Installation:
1. Remove the Shaft Collar (3).
2. Hold the handle (11) of the flexible shaft in one hand and the fitting collar (12) of
the flexible shaft in your other hand the collar of the flexible shaft in your other hand.
3. Raise the handle (11) end of the flexible shaft and shake gently. This will assist the
flexible shaft to become detached from the outer shaft and protrude from the
fitting collar. See Figure 1.
4. Loosen the collet nut (2) on your Rotary tool and insert the inner flexible shaft into
the collet (1) and tighten the collet nut (2) with the 2 in 1 wrench.
5. Hold the rotary tool in one hand and the flexible shaft fitting collar in the other and
let the other end of the flexible shaft hand down freely.
6. Gently shake the Rotary tool and flexible shaft and screw the flexible shaft fitting
collar (12) onto your Rotary tool. Gently shaking your Rotary tool and shaft will
assist the inner flexible shaft to locate correctly in the handle (11) of the flexible
shaft assembly.
7. Tighten the collet nut (2) fully using the 2 in 1 wrench provided. Always ensure bits
are tight before commencing any work with your tool.
8. Tighten the flexible shaft fitting collar onto your Rotary tool but do not over tighten.
Fig. 1
