11
SET-UP AND ADJUSTMENT (cont.)
2. To loosen the mitre lock knob (26), turn in an
anti-clockwise direction.
3. Adjust the mitre angle by loosening the mitre lock
knob (26) and pushing down on the mitre
adjustment lever (27) (Fig. 8). The rotating mitre
table (24) can now be adjusted to the left or the
right for the desired mitre angle.
4. Release the mitre adjustment lever (27) when the
rotating mitre table (24) is in place. Use the mitre
angle indicator (28) as a reference to the mitre angle.
5. When the rotating mitre table (24) is located at the desired angle, tighten the
mitre lock knob (26) to lock the rotating mitre table (24) in position.
Adjusting the Bevel Angle
The bevel lock lever (16) is used to lock the cutting head (3) at the required bevel
angle. The Mitre Saw bevel cuts from 0° to 45° to the left.
1. Turn the bevel lock lever (16) in an anti-clockwise
direction to release the bevel lock and adjust the
cutting head (3) to the required bevel angle as
shown by the bevel angle indicator (17) (Fig. 9).
2. Turn the bevel lock lever (16) in a clockwise
direction to tighten the bevel lock at the required
bevel angle.
WARNING!
Ensure the bevel lock lever (16) is tight before making a cut.
If it is not secured, the cutting head (3) may move during operation and
cause serious personal injury.
Changing the Blade
When fitting a new blade, check the squareness of the blade (13) to the rotating
mitre table (24) prior to use.
Refer to the Maintenance section of this manual for instructions.
Fig. 8
Fig. 9
!!
