Material Clamp
The material clamp (8) can be mounted on either side of the Mitre Saw behind the
rear fence (19). Depending on the cut, the material clamp (8) will need to be mounted
on the appropriate side. When performing bevel cuts, the material clamp (8) must be
on the right hand side of the fence (otherwise it will interfere with the cutting action).
1. Place the silver column of the material clamp (8) into
the hole behind the rear fence (19) (Fig. 10).
2. Secure by rotating the material clamp lock (9) in a
clockwise direction (Fig. 11).
3. Adjust the height of the material clamp (8) by using
the column locking knob. To release the material
clamp, turn in an anti-clockwise direction (Fig. 12) and
slide the material clamp (8) up or down the silver
column as required.
4. To clamp the workpiece turn the knob on the top of
the material clamp (8) in a clockwise direction (Fig. 13).
SET-UP AND ADJUSTMENT (cont.)
12
Fig. 10
Fig. 12
Fig. 13
Fig. 11
