9
Aligning the Suction Tube
WARNING!
Ensure the spray gun is disconnected from the mains power
supply before removing the paint pot.
Adjust the suction tube accordingly. It should be possible to spray the contents of
the container leaving hardly any material left in the container
Unscrew the Paint pot (7) from the spray gun, rotate anti-clockwise and pull away
from the body of the spray gun
Spraying with horizontal objects
Turn suction tube forwards as the suction tube
should be pointing toward the front of the spray
gun (Fig. 4).
Spraying overhead objects
Turn suction tube to point backwards as the suction
tube should be pointing toward the rear of the
spray gun (Fig. 5).
By pointing the suction tube in the proper direction
you will not have to refill the paint pot (7) as often.
Filling the paint pot
While filling the pot (7) with paint, filter the paint through a piece of nylon
stocking or a funnel which incorporates a filter to remove any lumps or particles.
DO NOT OVERFILL. Carefully screw the pot (7) into the spray gun ensuring it
is secure.
Adjusting the Spray Gun
Squeeze the trigger (8) while aiming the gun at a
piece of cardboard or scrap material and wait for
the spray to come out. Turn the spray regulator dial (6)
to required position for optimum results (Fig. 6).
Note:
The spray regulator dial (6) is a stop that limits
distance the trigger can be pressed.
OPERATION
Fig. 4
!!
Fig. 5
Fig. 6
6
Summary of Contents for SGP-300
Page 1: ......