Ozito SGP-300, Instruction Manual

CLEANING

12

!!

WARNING!

Always ensure that the Spray Gun is disconnected from the

mains power supply before making any adjustment or cleaning.

Clean After Every Use 

After every use it is essential that you clean the gun thoroughly. This will prevent any
blockages occurring and provide reliable performance when you next come to use it.

1. Unplug the spray gun. Open trigger so that the coating material in spray gun runs

back into the container.

2. Unscrew the container. Return remaining material into the material can.

3.   Fill the paint pot with solvent or water.

Note:

Only use solvent with a flash point of over 21°C.

4.   Clean the paint pot and suction tube with a brush.

5. Screw container back in place. Plug the spray gun in and spray the solvent or water

into a container. 

6. Repeat the above procedure until clear solvent or water comes out of the nozzle.

7. Unplug the spray gun.

8. Then completely empty  the paint pot. Always keep the container seal free of

coating  material and check for damage.

9. If the housing of the gun requires cleaning dip a cloth in the solvent or water,

ensuring the cloth is not dripping, wipe the exterior of the spray gun.

10. Unscrew the air cap nut. Remove air cap (1). Clean the air cap and nozzle with stiff

brush and solvent or water.

11. Turn both the Quick release knobs (3) on both sides

of the spray gun to the “Unlock” position, pull and
separate the spray gun from the paint head (Fig. 13). 

12. Clean the rear of the paint head  with appropriate

cleaning solution (Fig. 14). Turn the tube anti-
clockwise  and pull to disassemble from the paint
head. Then clean the suction tube.

Fig. 13

Fig. 14