13. The suction tube can be disassembled for
further cleaning by turning clockwise then pull
to disassemble (Fig. 15).
14. Take note of the 3 holes on the suction tube, if
blocked clean using the provided cleaning
needle (Fig. 15A). The 3 holes are used to
pressurize the paint pot (7) for the paint pickup.
If these holes are partially blocked it will result in
uneven and inconsistent spraying.
15. Thoroughly clean the suction tube using clear
solvent or water before reassembling.
16. Prior to storing the Spray Gun, ensure it is completely dry. This will minimise
residue build-up for the next use.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the tool by an unauthorised person or by mishandling of the tool.
Air Filter
Before storing inspect the air filter (4) to see if it is excessively dirty. If it is dirty
follow the steps below to replace it.
WARNING!
Always ensure that the Spray Gun is switched off and
unplugged from the power supply before making any adjustment.
Filters can be purchased in packs of 2 (Ozito p/n SPSPG300-03) and are available
from your local Bunnings Warehouse.
1. Remove the filter cover (a) with a flat screwdriver
(not supplied) or similar tool (Fig. 16).
2. Remove the inner filter cover (b).
3. Remove the dirty filter (c) and wash in water or
replace with a new one (Fig. 17).
4. Place the inner cover (b) over the filter (c) and
secure the filter cover (a) back onto the
spray gun.
WARNING!
Never operate your Spray gun without the air filter. Dirt could
be sucked in and damage the operation of the unit.
13
CLEANING (cont.)
Fig. 15
Fig. 16
Fig. 17
!!
!!
a
screwdriver
a
b
c
Fig. 15A
Summary of Contents for SGP-300
Page 1: ......