Ozito SGP-300, Instruction Manual

14

MAINTENANCE

If required the paint head plunger can be removed and cleaned. This is a maintenance
task and should not be required on a frequent basis. If the paint has been allowed to
dry in the paint head or the spray gun has had a lot of use then removing and
cleaning or replacing the plunger may restore the original spray gun performance.

1. Disassemble the paint head from the spray gun body by turning both the quick

release knobs (3) on both sides  of the spray gun to the "Unlock" position, pull
and separate the paint head from the spray gun body.

2. Using a 8mm socket (not provided) unscrew

carefully and remove the paint head plunger
assemble from the rear of the paint head (Fig. 18).

3. Clean the paint head plunger assembly and paint

head and remove any paint using clear solvent 
or water.

4. After cleaning reassemble the plunger assembly in

the correct order (Fig. 19) and refit to the paint head.

5. Assemble the paint head to the spray gun body.

Note: 

Do not use abrasive material to clean the plunger as this may affect the

performance of the spray gun.

Fig. 18

Fig. 19