1
4. ADJUSTING THE SPRAY GUN
5. HOW TO SPRAY
SGP-5000
1 For vertical surfaces use a
horizontal fan. This is done
by rotating the air cap into
the position shown to the
right.
1 Unscrew and remove the
air cap from the paint head.
2 Remove the nozzle and
replace with the desired
size. Screw the air cap
onto the paint head to
secure the nozzle.
2 sized nozzles are provided with this spray gun. The 2mm
diameter nozzle (colour: red) should be used for lower viscosity
materials. The 2.5mm diameter nozzle (colour: black) should be
used for higher viscosity materials.
2 For horizontal surfaces use
a vertical fan. This is done
by rotating the air cap into
the position shown to the
right.
3 For corners, edges and
other hard to access
places use a round fan.
This is done by rotating
the air cap into the position
shown to the right.
To change spray patterns
simply loosen the air cap and
rotate to the desired position.
Ensure that the air cap is
tightened again to secure in
place.
Changing Nozzles
Choosing Spray Patterns
CAUTION:
PROTECTIVE CLOTHING SHOULD BE WORN
DURING OPERATION TO AVOID INJURY.
WARNING:
NEVER UNDER ANY CIRCUMSTANCES AIM THE
NOZZLE AT ANOTHER PERSON OR ANIMAL. THE HIGH
PRESSURE AT THE NOZZLE COULD CAUSE INJURY.
1 Ensure the paint and
thinners has been
thoroughly mixed.
3 Adjust the suction tube
and air cap into the desired
position for the job.
5 Start away from your
workpiece and evenly
control the speed
of movement while
maintaining distance and
angle to the piece.
2 Ensure the viscosity of
the mixture is less than 60
DIN-S.
4 Spray onto scrap material
to check that the spray
pattern is correct.
6 Overlap each stroke by
2cm to achieve an even
coat.
PAINT
THINNERS