2. LOADING NAILS
1 Hold the tool upside down.
This staple nailer only accepts 18 Gauge C1 Brad nails up to 15mm in
length. Other types of nails will jam the unit.
3 Insert a row of nails into the opening behind the nose piece.
Be sure to align them to the side marked with a nail marker so that
the nail head is against the internal groove.
2 Squeeze the magazine latches on either side of the tool and pull the
magazine out of the tool.
4 Push the loaded magazine back into the unit until it clips into place.
a
b
3. CONTROLS
Switching On and Off
1 To supply the tool with power,
push the power switch to the
“I” position.
2 To turn off, push the power
switch to the “O” position.
CAUTION!
ThE POwER SUPPLy fOR ThIS PROdUCT
ShOULd bE PROTECTEd by A RESIdUAL CURRENT
dEvICE (RATEd AT 30MA OR LESS).
