Loading Fasteners
This tool only accepts T50 or JT21 staples or C1 Brad nails with
the dimensions specified in this manual. Other types of staples,
including paper staples, will jam the unit. For best results, load a
full row of staples before use.
1. Squeeze the magazine latch
and pull the slider out of the
tool.
3. Insert a row of staples or
nails into the magazine.
Note:
For nails, be sure to
align them to the side with the
embossed nail icon so that
the nail head is against the
internal groove.
4. Push the magazine slider
back into the unit until it
clips into place.
2. FASTENER SELECTION
3. LOADING THE MAGAZINE
3.6V
STAPLE NAIL GUN
3.6V
STAPLE NAIL GUN
3.6V
STAPLE NAIL GUN
WARNING!
ENSURE THE TOOL IS SWITCHED OFF
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
Staples
Accessories to suit this staple gun can be purchased from
Bunnings Warehouse.
This tool accepts staples with the measurements below:
Nails
This tool accepts nails with the measurements below:
4-8MM
JT21
STAPLES
4-8MM
T50
STAPLES
4mm
6mm
8mm
11.4mm
0.55mm
0.74mm
4mm
6mm
8mm
10.5mm
1.25mm
0.5mm
10MM
C1 BRAD
NAILS
2mm
1mm
10mm
4-8MM
JT21
STAPLES
4-8MM
T50
STAPLES
4mm
6mm
8mm
11.4mm
0.55mm
0.74mm
4mm
6mm
8mm
10.5mm
1.25mm
0.5mm
10MM
C1 BRAD
NAILS
2mm
1mm
10mm
4-8MM
JT21
STAPLES
4-8MM
T50
STAPLES
4mm
6mm
8mm
11.4mm
0.55mm
0.74mm
4mm
6mm
8mm
10.5mm
1.25mm
0.5mm
10MM
C1 BRAD
NAILS
2mm
1mm
10mm
