MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way.
Please recycle where facilities exist. Check with your local council
authority for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
The tool loses power during use
• Battery could be low and requires charging.
• The tool could have overloaded due to excessive pressure. Turn the product
back on and reduce load.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
SPARE PARTS
WARNING!
When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of
fire, electric shock, personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool off
in an emergency, before operating the tool.
Save these instructions and other documents supplied with this tool for future
reference.
The charger has been designed for 230V and 240V only. Always check that the
power supply corresponds to the voltage on the rating plate.
Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia
and New Zealand.
This tools charger is double insulated therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by an electrician or a power tool
repairer in order to avoid a hazard.
Note:
Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged or
defective may result in a risk of fire and electric shock.
ELECTRICAL SAFETY
Warning
Wear eye protection
Read instruction manual
Ah
n
0
Amp hour
Regulator compliance
mark (RCM)
r
No load speed
V
Volts
Hz
Hertz
ac/~
Alternating current
Direct current
dc/
/min
Diameter
Revolutions or
reciprocation per minute
WARNING!
Always ensure the tool has completely stopped and the
battery is removed prior to any maintenance
• After each use, blow air through the tool housing to ensure it is free from all
dust, dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and
shorten the life of the tool.
• If the housing of the reciprocating saw requires cleaning, do not use solvents but
a moist soft cloth or soft brush only.
• Never let any liquid get inside the tool, never immerse any part of the tool into
liquid.
• When not in use, the reciprocating saw should be stored in a dry, frost free
location not within the reach of children
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the reciprocating saw by an unauthorised person or by
mishandling of the reciprocating saw..
