15
I N S P I R E D B Y N AT U R E / / D R I V E N B Y T H E E L E M E N T S
5
6
5
6
Maintenance
Speed System and Bridle lines should be regularly checked and maintained in the correct trim or the
kite will not perform as designed. If they are worn or not to factory specification (+ or - 15mm) they
must be replaced. How To videos and a Bridle Check PDF with all measurements can be found at
www.ozonekites.com
You must inspect all your equipment before and after every use. Check the entire kite including
upper and lower surfaces, line attachment points, speed system and bridles. Immediately replace any
worn or damaged parts with original parts only.
Pre and POsT use check lisT.
• control system and quick release: Check for abrasion/wear, if any part is damaged replace it
immediately. Reload/release the Quick Release to check the system is functioning correctly. Store
your Control System with the Quick Release open. Reload the next time you set up your kite.
• lines: Check them every time you wind and unwind the lines. If one of them is damaged, change
the corresponding pair.
• speed system: Check the pulleys and lines for abrasion, if any are damaged change them
immediately.
• bridle lines: Check the bridle lines for abrasion, if any are damaged change them immediately.
• sail: Check there are no holes or tears in the sail. If your sail is torn, you can repair it with the sticky
cloth, provided in repair kit. To repair the sail, make sure it is clean and dry. Prepare two pieces of
sticky cloth, one for each side of the damaged area. The patch should cover the hole by at least 2cm
all round. Lay flat and stick on both sides.
• Packing: Dry your kite after use away from the sun and direct heat. Never leave a wet kite in its bag.
Store your kite in a dry place out of the sun. Never wash or clean it with detergent.
Summary of Contents for Pure V1
Page 1: ...1 p u r e v 1 M a n u a l ...
Page 16: ......
