8
GPT3G003 OzSpy User Manual
http://maps.google.com/maps?q=N40.756441,W73.986378
Battery:91%
Note: The LBS location precision is not very high, in the city maybe 30-50 meters, in the
country side maybe over 300 meters according to the GSM base station density. So this location
can only be used as a reference. If the LBS cannot locate either, the tracker will reply “Cannot
Locate now, Please Try Later!”.
5.
Set System Working Mode
Send SMS “MODE*123456*X” to the tracker, “MODE” is command, “123456” is password,
“X” is the working mode, it is 1, or 3. if the “X” is 3, the SMS command should be
“MODE*123456*3*Y”, “Y” is the sleep time from 01-99, unit is hour. after receive the
command, the tracker will reply by SMS “Working mode set to X (1 Working,3 Cycle On/Off
GPRS)”. The working modes are described below:
Mode 1 (Factory Mode) ------ Continuously Working (Locate every 5 minutes)
This mode is the default working mode. under this mode, the tracker can receive SMS or
calls, locate and report by GPRS to the sever every 5 minutes
. N.B This mode uses the most
battery.
Mode 3 ------ Cycle ON/OFF & Upload Location to Server by GPRS
In this mode, the system ON / OFF is controlled by a timer (interval time is Y hours). The
tracker will power on automatically and locate with GPS and then upload the location
information to server by GPRS, and then a few minutes later, the tracker will power off
automatically, and the timer will begin to count, after the time is up, the tracker will power on
again and then locate & upload the current location to server by GPRS, and power off again.
When the timer is up it will repeat the above process. The battery power consumption is very
low in mode 3, normally this mode is used for checking location every setting time (For example
check one time every day or every hour), not used for real time tracking.
