-
9
-
GPT3G005COV User Manual
please sending SMS “CHECK*123456” to the tracker to check. if the APN & GPRS are not right, please set by
the following description.
Send SMS “APN*123456*apnname” to the tracker, in which, “APN” is the fixed command, “123456” is the
password and “apnname” is the APN name of a mobile phone company. Having successfully been made,
there will be a SMS “APN: apnname”.
Send SMS “USERNAME*123456*username*password” to the tracker, “USERNAME” is a command,
“123456” is the password of the tracker; “username” is the mobile company GPRS user name, “password” is
the mobile company GPRS password, if the operation is success, the tracker will send back the information
“Username:username, Password:password”, if the password is not right, the operation is fault, the tracker will
send back information “Wrong Password”.
7.
Enable And Disable Overspeed Alarm (No Platform Necessary)
Send SMS “OVERSPEEDALARMON*123456*SSS” to the tracker number, “OVERSPEEDALARMON” is
command, “123456” is password, “SSS” is the setting alarm speed, unit is km/hour. The tracker will send back
the information “Set Overspeed Alarm On :SSS km/h” .
After enable overspeed alarm, the system will check the speed every 5 minutes. If the speed is higher than the
setting speed, the tracker will send alarm and location information by SMS to the authorized phone number A
(only send to A), The authorized phone will receive max 3 alarm SMS per hour, one hour later it will be active
again.
The overspeed alarm SMS is as follow:
Overspeed Alarm
Current Speed:110km/h,Setting:100km/h
Battery:88%
Send SMS “OVERSPEEDALARMOFF*123456” to the tracker number, “OVERSPEEDALARMOFF” is
command, “123456” is tracker password, the tracker will send back the information “Set Overspeed Alarm Off ” .
Note: In the default, the over speed alarm setting is OFF.
8.
In & Out Geo-fence Alarm (5 Geo-Fences Can be Set) set or delete
Total 5 Geo-fences can be set, the geo-fence is a circle and the radius is set by SMS, and the center of the
circle is set by tracker current location or another position ( including longitude and latitude )set by SMS.
Note: After enable the geo-fence alarm, when the unit is moving, it will detect the fence status live.
Default all the geo-fence alarm is OFF.
The command is “SETFENCE*123456*Geo-Name*GGG*22.680307N*114.146843E”
“Geo-Name” is the fence’s name user defined, like school, family or other name, max 8 characters and can
be added up to 5 different fence.
“GGG” is the fence’s radius, from 001 to 999, unit is km.
