2
Use of the device
Inserting the memory card
NOTE:
A Micro SD memory card must be installed before operating the camera function of the device.
Press the card into the Micro SD card slot until you hear a click tone. To remove the memory card, push
it. Then it will slide partially out of the device.
⚫
Video recording
: Set operation switch to
V
position, long press power key, PINK LED will turn on
firstly, then RED LED flashes 3x and turns off. Camera enters into video recording mode. The video will
be saved automatically.
⚫
Motion detection:
Set the switch to
MD
position, long press power key, PINK LED will turn on firstly,
then BLUE Flashes 3x and turns off. Camera enters into motion detection mode. When a motion is
detected, the video will be recorded and saved automatically.
Note:
Maximum file length of video recording is 3 minutes, after that a new file is created. After 1 minute
without any operation the camera will automatically power off.
⚫
Support loop recording:
When the memory card is full, it will automatically delete the first videos
and continue to record.
⚫
Recording while charging :
5 seconds after connected to the adapter, same operation with normal
using.
⚫
Turn off camera:
Long press power key , PINK LED flashes 3 x and turns off. The camera turns off.
⚫
Connecting with PC:
Power off the device then connect it with PC using USB cable. Do not have
any operation on the device during this connection. If the device is not read by PC, please re-connect
and make sure the USB driver/cable is alright.
⚫
Charging the device:
Connect the Micro USB port of the charging cable to the device. Then connect
the USB port of the charging cable to the USB port of an AC adapter .During charging the PINK LED is
flashing. When it is fully charged, PINK LED will steady on.
⚫
Reset:
To reset camera, insert a pin into the reset hole and hold for about 2 seconds. After 1 minute,
the camera is reset.
⚫
Set Date and Time stamp
The date and time will be revised for video in next recording.
1. Plug in the USB cable to the camera and to the computer.
2. Go to <My Computer> or Computer or Explorer.
3. The camera will be recognized as removable Disk Drive.
4. Double left click on removable Disk Drive and it will bring up the Video folder. DO NOT OPEN IT !
5. Edit the text document named“time”by double left click on the “time.txt”document.
6. Fill in the current Year-Month-Day hour:minute:seconds [eg: 2018-01-01 12:00:00 Y] (
Change“Y” to
“N”, the time stamp will not show up
)
Go to File and Save, then close file.
Power off the device and restart. The device now has the current date and the current time.
Warnings
⚫
Do not attempt to disassemble the device, it may result in short-circuit or even damage.
⚫
Do not drop
or shake the device, it may break internal circuit boards or mechanics.
⚫
Use it under normal
temperature and normal humidity.
⚫
Do not put it in a moist working environment since it is not
waterproof.
⚫
Do not use it directly against strong light, to avoid damage optical device.
⚫
Do not use
under high dust density environment, to avoid the lens and other components stain dust and effect the
camera quality.
⚫
Do not make its strong shock, vibration, do not use under high magnetic field.
⚫
Keep
the device away from little children.
