11
Step 6 Attaching the latches
Step 7 Attaching the two
large gas struts
Study the position of the catch-hook that is
attached to the timber baseboard, the latch
position on the trailer is required to line up
exactly with the catch-hook. Attach both latch
and backing plates to the trailer, these should be
approximately 20-30cm from the front and 20-
30cm from the rear of the trailer on the right hand
side while looking forward towards the tow hitch
(at the front of the trailer for the Camper Trailer
Tent 8 models). Here again use the backing plate
as the template for the hole positions. Once this is
in place align the position of the catch-hook that is
attached to the timber base board, see Figure 15 .
For camper trailer tent models 6, 7 & 9 Classic with
the optional gas tilt attachment kit, position the 2
rope hooks on the rear tailgate, locate the position
that will allow adequate tension of the shock cord
rope from the vinyl dust cover, see Figure 13.
Fitting position for the two large gas struts for the
Camper Trailer Tents Outer Ridge 375, Outer Ridge
475, 9, 9 Deluxe, 12, 12 Twin & 12 Deluxe and
Camper Trailer Tent 6, 7 & 9 Classic when optional
gas tilt attachment kit is purchased, see Figure 16.
Fitting position for the two large gas struts for the
Camper Trailer Tent 8 & 8 Twin, see Figure 17.
Figure 14
Figure 15
Figure 16
Figure 17
Attaching the Camper Trailer
Tent to trailer Instructions
