16
Now get down from the bed platform and
onto the vinyl floor at ground level. Extend the
adjustable front side pole and front side door
pole, this will tension the roof and walls until
firm. If required the front side door poles over the
doorway can be removed from the hub plate by
releasing the locking pin and then extend the
front side door pole towards the rear wall and
locate the end of the front side door pole into the
pocket provided on the floor next to the door,
see figure 25. To avoid damage, it is important
to re-attach the front side door pole to the hub
plate before folding up the Camper Trailer Tent.
Due to the extended length of the ground level
room, on Camper Trailer Tent models 7, Outer
Ridge 475, 12, 12 Twin & 12 Deluxe an additional
steel hoop pole is supplied to support and
tension the rear wall and roof area, this hoop
pole is made up of the forward side and ridge
poles, see figure 25. The forward ridge poles
are inserted into the canvas pole sleeve along
the wall and roof junction, the forward ridge
pole can remain in this sleeve. Next connect the
forward side poles to the forward ridge pole and
secure the other end of the forward side poles
into the pocket provided on the floor and wall
junction. Finally adjust the height of forward side
poles to allow the roof and rear wall to become
firm and create a uniform roof slope to allow
water to run o
ff
without ponding.
For Camper Trailer Tent model Outer Ridge 375 &
Outer Ridge 475, OZtrail provides one spreader
pole #55 with “C” clips at each end to strengthen
Set up and Assembly
Instructions
the structure of the roof frame, see figure 25 (page
20).
For Camper Trailer Tent model 8 & 8 Twin, OZtrail
provides three spreader poles #5 with “C” clips at
each end to strengthen the structure of the roof
frame. Two poles #4 are provided as support legs
for the front ridge pole in the roof, see figure 25
(page 21).
For all Camper Trailer Tent models 9, OZtrail
provides two spreader poles #5 with “C” clips at
each end to strengthen the structure of the roof
frame. Two poles #4 are provided as support legs
for the front ridge pole in the roof, see figure 25
(page 21).
For all Camper Trailer Tent models 12, OZtrail
provides two spreader poles #5 with “C” clips at
each end and two spreader poles #55 with “C” clips
at each end to strengthen the structure of the roof
frame. Two poles #4 are provided as support legs
for the front ridge pole in the roof, see figure 25
(page 22).
