18
Step 3 Assembling the
centre ridge and upright
poles.
Step 4 Assembling the side
ridge and upright poles.
For Camper Trailer Tent models 6 & 7, place the
eye end of the middle ridge pole (#6) over the
spigot tip of the long pole #203 and get your
friend to hold pole #203.
Using the thicker end of pole # 901 and making
sure the adjustment screw is facing down, place
the eye of spreader poles #901 over the spigot of
pole #203. Place the eyelet in the middle of the
canvas awning over the spigot of pole #203 and
adjust the ridge pole # 6 till the canvas is tight.
Raise pole #203 to approximately the height
required and place the loop of the guy rope over
the spigot, tightening the ropes enough to hold
the pole.
For all Camper Trailer Tent models Outer Ridge
375, Outer Ridge 475, 8, 9 Classic, 9 & 12, place
the eye end of the middle ridge pole (#8) over the
spigot (point) of the long pole #7 and get your
friend to hold pole #7. Using the thicker end of
poles #2 & #3 and making sure the adjustment
screw is facing down, now place the eye of
HELPFUL HINT
Place the loop of a spare guy rope over the
spigot of the centre upright pole to hold the
eyelet down so that the canvas does not pop
o
ff
the spigot while you continue with the side
ridge pole assembly. This can be tied to the
pole below the adjustment nut or fixed to the
adjustment nut.
For Camper Trailer Tent models 6 & 7, place the
eye of one of the spreaders poles # 901 and the
corresponding side ridge pole # 6 over a corner
pole # 201 spigot, now place the corner eye of
the canvas awning over the spigot and adjust
the length of both poles to pull the canvas
tight. Raise the pole # 201 to the approximate
height and place the loop of the guy rope over
the spigot, tightening the ropes enough to
hold the pole. Repeat the above process for the
remaining side ridge and upright poles.
For all Camper Trailer Tent models Outer Ridge
375, Outer Ridge 475, 8, 9 & 12, place the eye
of one of the spreaders poles # 2 or 3 and the
corresponding side ridge pole # 8 over a corner
pole # 6 spigot, now place the corner eye of the
canvas awning over the spigot and adjust the
length of both poles to pull the canvas tight.
Set up instructions for the
Camper Trailer Tent awning
spreader poles #2 & #3 over the spigot of pole
#7, make sure you position the long pole on the
long side of the awning. Place the eyelet in the
middle of the canvas awning over the spigot of
pole #7 and adjust the ridge pole #8 until the
canvas is tight. Raise pole #7 to approximately
the height required and place the loop of the
guy rope over the spigot, tightening the ropes
enough to hold the pole.
Step 2 Attach the ridge poles
to the frame of the Camper
Trailer Tent
For Camper Trailer Tent models 6 & 7, place the
bent spigot of the ridge poles (#6) and for all
Camper Trailer Tent models Outer Ridge 375, Outer
Ridge 475, 8, 9, 12, place the bent spigot of the
ridge poles (#8) through the Eye Bolts at the points
adjacent to the inner frame poles on the outer wall
of the Camper Trailer Tent leaving them hanging in
place, see figure 26 (page22).
