23
Disassembly and Folding
instructions
HELPFUL HINT
OZtrail recommends two people are
required to pack away the Camper Trailer
Tent. It is a good idea to include a dustpan
and brush in your camping kit to clean the
floor before packing it away. It is also helpful
to remove any tree leaf or debris from the
roof before folding.
HELPFUL HINT
Use a ridge pole with the hooked spigot
placed into the corner eye of the awning to
raise the awning roof up and carefully draw
it over the top of the Camper Trailer Tent. Do
this slowly to avoid snagging the awning
roof and causing any damage.
Step 1
Step 3
Step 4
Step 5
Step 6
Step 7
Step 2
Close all windows, awning and doors not needed
for folding the camper. If present, remove
sun room floor and walls from the awning by
following the reverse order of the assembly
instructions. Lay them on the ground and fold
in half, third or quarters. The width of the folded
sunroom floor or walls should be the length of
their carry bag, see Figure 28.
Inside the Camper Trailer Tent, replace the front
side door poles into the hub plate on the bed
base making sure they are properly clipped into
place and undo the zips in the vinyl wall adjacent
the hub plates.
Remove all guy ropes and tent pegs with a claw
hammer or peg puller and put them into their
bag.
Collapse the awning frame by removing and
disassembling the poles in the reverse order of
the assembly instructions. Place the poles in the
pole carry bag and tie shut.
Fold the awning back over the top of the main
Camper Trailer Tent.
For Camper 7 & 12 models only, release the
tension bolt on the forward side poles and
remove the forward side poles and place these
poles into the pole carry bag. The forward ridge
pole can remain in the pole sleeve, see Figure
25, from the previous Set up and Assembly
Instructions section.
Release and remove any spreader poles #5 and
#55 (with “C” clips at each end) that have been
used to brace the awning and the main frame.
Release and remove any upright support poles
#4 that were used. Place the poles into the pole
carry bag. Release the Posibrace™ Velcro™ tab
points that attach the awning roof to the poles.
Figure 28
Release the tension bolt on the front side/door
poles and allow the telescopic poles retract to
their minimum length. Allow a portion of the
door to remain unzipped to allow air trapped in
the Camper Trailer Tent to escape during folding.
Fold into a
rectangular shape
Opening for
air to escape
The width should not
exceed the length of the
pole bag
