6
Assembly Instructions cont.
Figure 8
Figure 7
Step 8 Set up the Awning
and Guy Ropes
The awning is set up by hooking the spreader
bar into the tents centre hub with the hooked
end (Figure7). The other end marries up with
the longest of the three steel awning poles.
Insert the poles into the awning and then use a
guy rope and peg to secure them.
Peg out the guy ropes attached to the fly, make
a loop (about 30 to 50 cm long) with the slider
on the end of the rope and peg out as far as
possible from tent. Ensure all peg down points
are utilised and all guy ropes are attached firmly
and remain firm as indicated in Figure 8.
IMPORTANT
In severe weather conditions the tent should be
dismantled whilst you seek shelter in safety –
such as your vehicle.
