background image

8

•     Temporary use only. Although our fabrics are 

treated for extra UV resistance, continuous 
exposure to sun light will reduce the life 

of the fabric. Fading of colour is an early 

warning sign. OZtrail products are not 
designed as permanent dwellings or 

structures.

•     During rain always lower awnings to avoid 

water ponding.

•     Never store a wet and/or soiled tent/shelter; 

as mildew and corrosion can form. Always 
allow the tent to dry completely before 
packing and stowing. If mildew occurs, use 
a soft bristle brush or sponge with mild 

detergent to clean it off. After beach use or 

wet weather treat all zips, poles and pegs 
with silicon spray.

•     The elastic shock cord within the poles is 

provided for easy assembly of the poles. 

The shock cord is not required for any 
structural reason. The poles and tent 

perform perfectly well without the shock 
cord. Age, over stretching and mishandling 
may cause failure. Shock cord is not covered 
by warranty. It’s easy to replace, see the 
instructions on page 12.

•     Sometimes the zipper coil bursts open or 

does not close. This could be due to wear 

or metal fatigue. The problem can be easily 

fixed, see the instructions on page 15.

•     Always carry a roll of heavy duty tape for 

simple repairs to small rips, cuts and ash 
burns. This not only blocks the hole, it will 

prevent further tearing. Heavy Duty tape is 

also helpful for emergency pole repairs and 
many other uses around the camp site.

•     When removing pegs, do not use the 

webbing or corner of the tent as your 
handle. Either use another peg, a peg 
remover or the claw of a hammer hooked 
under the peg to remove them.

Prolonging The Life Of Your  

Tent/Shelter

HELPFUL HINT
CONDITIONING YOUR NEW TENT
Once you get your new tent home, it is 
important to condition the tent. Simply 
pitch your tent and wet it down with your 
garden hose until the fabric and all seams 
are saturated. Pay particular attention to the 
seams - the thread swells when wet and blocks 
the needle holes. The needle holes also shrink 
around the thread. The fabric also benefits 
from this because the fibre swells into the 
weave and the waterproof treatment settles 
within the fabric. Let the tent dry completely 
before repeating this wetting and drying 
process until there is no leakage during hosing. 
Always pack your tent away dry.

Summary of Contents for DTH-SB2C-C













Reviews: