DISASSEMBLY INSTRUCTIONS
Release guy ropes. Release velcro that attaches the fly to the poles.
Remove fly from tent. Lay fly flat on ground and fold the fly in half, third or quarters.
(folding depends on the length of the pole carry bag.)
Unzip doors and windows, remove the climate control vent rods, collapse the tent, removing
and disassembling the poles. Place the poles in the pole carry bag and tie shut.
Remove pegs. Do not remove pegs from the ground by pulling on peg loops.
This may cause the peg loops to tear out of the seam.
Spread the tent out flat with all loose fabric within the edges of the tent base.
Try to flatten the tent as much as possible.
Fold the tent in half, third or quarters. (folding depends on the length of the tent pole
sections.) Place the folded fly in tent as you make the last fold.
Place the pole bag on back end of tent (trapped air is more easily forced out of the open
door when you are rolling up the tent.) The folded tent should be the width of the pole bag.
Beginning at the back end, roll your tent tightly around the pole bag, forcing out excess air
as you roll. Keep tent edges straight and pole bag centred as you roll.
When tent is rolled up, tie straps around it and place into tent carry bag with peg bag,
instruction sheet, and other miscellaneous parts. If tent won’t fit into bag, unroll and re-roll
more tightly.
The width of the tent
should not exceed
the length of the
pole bag
Front of tent
(door unzipped)
1
3
4
5
6
7
2
Fold tent into a
Rectangular shape
ROLL
8
Never store a wet and/or soiled tent, as mildew and corrosion will form within a few days.
This condition is not covered by warranty. Always allow tent to dry completely before packing and stowing.
