Change now the soundproofing material worn out, cleaning the covers that seal the
silencer and continue to the assemblage of the new soundproofing material. Add as
denoted in the figure 6.5.1 and 6.5.2 a sealing paste, resistant to high temperatures
on the points of junction, fix two new rivets in the original position, change the gasket
silencer-muffler.
You now proceed bashful for the assemblage of the silencer. It will be possible
to purchase soundproofing material from the Vittorazi / dealer Vittorazi. If the
soundproofing material is purchased in a spare parts shop for car/motorbikes, you
don’t exceed with the quantity of soundproofing material, the effect after few hours
will be contrary to the desired one. We recommend to cut out a square of the same
dimensions of the material just replaced.
We advise to inspect at the end of every use of the motor the conditions of the rubber
mountings. In the case which one of these presents a crack or a detachment of the
rubber, immediately replace it. Reached the 100 hours, replaces the rubber mountings
of the motor (4pc) and the exhaust system (2pz). For a correct installation of the new
rubber mountings, you compare the paragraph 3.2.
6.6
RUBBER MOUNTINGS
A first control of the components of the pull starter is recommended to 25 hours. Just
removed the manual starting from the plate, the hooks/splines will be visible. Verify the
conditions and the slide of the hooks, lifting them with a finger. In every case add some
oil (for rusted bolts) on the pivots of sliding.
6.7
PULL STARTER FLY100EVO
(fig. 6.7)
The manual starting: as first operation loosen the knot that stop the handle of starting
and unthread the rope from the eyelet drives, suitable in figure 1.
Now positioning the rope in the hollow of the pulley as shown in figure 2, rotate the
pulley of wrapping clockwise, to lose the tension given by the spooling spring.
Unscrew the central bolt of 6mm, figure 3.
Manteinance.
USER MANUAL
19
Summary of Contents for RM80
Page 1: ...page 2 page 10 page 28 page 36 USER MANUAL...
Page 39: ...Electronic box USER MANUAL 39...
Page 40: ...40 USER MANUAL...
