Lift the pulley with the help of a small screwdriver holding back the spooling spring that
is found under the pulley, figure 4 (you will avoid to go out this spring). If for distraction or
accident the spooling spring escapes, can be rearranged (provided of patience) manually
in the original position.
In the figure 5, freed the pulley, is shown the spooling spring.
Assemblage: add grease to the spooling spring and the pivot where slides the pulley,
then insert the pulley in the pivot drives.
Tight the screw of 6 mms, inserting lock-tight of medium resistance (if the washer creates
attrition with the pulley, turn upside-down the washer).
Position the rope in the hollow as in figure 2; turn the rope in the pulley wrapping, up to
fill it. Always maintaining the rope in the hollow, rotating counterclockwise unitill the origin
of the tension of the spooling spring begin; from this position rotate counterclockwise the
pulley of two complete turns, then maintain this position (hold the pulley) and return to
insert the rope in the eyelet drive, as in figure 1.
Finally always holding the pulley mark the rope with a pen in the adjacent zone the
structure, picture 6. Once made the sign, free the pulley and you can leave also the rope
reenters in the wrapping.
If necessary, for the remainder installation returned to the indications of the paragraph 3.8
Mantenimiento.
20
USER MANUAL
Summary of Contents for RM80
Page 1: ...page 2 page 10 page 28 page 36 USER MANUAL...
Page 39: ...Electronic box USER MANUAL 39...
Page 40: ...40 USER MANUAL...
