Page | 7
4.4.
VIA SUB Remote control software
The remote control software enables the user to adjust EQ, delay, polarity, noise gates and other
aspects of the VIA series performance. Once the unit is connected to the computer, any changes
made on the computer will become active, but will NOT be saved onto the amplifier, until the preset
is stored onto the VIA series amplifier.
HARDWARE REQUIREMENTS
Essential:
Windows computer running windows XP or newer operating system. At this time, compatibility with
windows 10 is not guaranteed (but has been tested with good results).
Spare hard drive space of 50MB
Recommended:
RAM
2GB
Operating System
Windows 7
Processor
Dual core 2gHz or higher
COM CABLE
The COM cable is an accessory, available from P.Audio, which allows the user to take control of the
VIA series amplifiers from any windows based PC. Upon connecting the COM cable and opening VIA
software, a dialog screen will appear checking options for connecting to the device in question. To
ensure communication occurs on the right COM cable, this must be selected from the drop down
list.
