7
4.
REMOTE
SOFTWARE
–
XT
S
ERIES
The remote control software enables the user to adjust EQ, delay, polarity, noise gates and other aspects of the XT series
enclosures performance. Once the unit is connected to the computer, any changes made on the computer will become active,
but will NOT be saved onto the amplifier, until the preset is stored onto the XT series amplifier.
4.1.
HARDWARE
REQUIREMENTS
Essential:
Windows computer running windows XP or newer operating system. At this time, compatibility with windows 8.1 is not
guaranteed.
Spare hard drive space of 50MB
Recommended:
RAM
2GB
Operating System
Windows 7
Processor
Dual core 2gHz or higher
4.2.
COM
CABLE
The COM cable is an accessory, available from P.Audio, which allows the user to take
control of the XT series amplifiers from any windows based PC. Upon connecting
the COM cable and opening XT software, a dialog screen will appear checking
options for connecting to the device in question. To ensure communication occurs
on the right COM cable, this must be selected from the drop down list.
For linking between amplifiers, standard CAT5 type cabling can be used.
To connect the COM cable to the XT series amplifiers, simply connect the USB plug
to the windows computer, and plug the other end into the socket on any available
XT series amplifier. Ensure to align the plug correctly and do not exert too much
force onto the USB plug.
4.3.
ID
Once the required amplifiers are all linked together, the software can be started.
To start the software, click start
All Programs
XT SERIES
XT SERIES
Application.
Once the COM cable is chosen, the software needs to know which units to
communicate with. ID for XT series amplifiers as set by the factory range from 1-
32, although the user to is free to change this as they see fit with the ‘configure ID
Device’ utility. The software can communicate with a maximum of 32 units at
once.
Once all is set up, press OK and the software will launch.
Summary of Contents for XT Series
Page 1: ...P AUDIO XT SERIES MANUAL...
