6.1
TROUBLESHOOTING
WARNING
Do not open or disassemble the product. Opening the product can prove hazardous and will void the warranty.
ATTENTION!
In the event that the product is defective or damaged, contact the dealer you purchased the luminaires from,
or P.L. Light Systems directly. Never switch on a defective or damaged luminaire.
What can you see?
What does it mean?
Possible cause?
What should I do?
The luminaire does not
emit any light
• The luminaire is
switched off
• No voltage is present
• The luminaire
temperature is too
high
• The voltage
is too high
• The voltage
is too low
Check the voltage and ensure
that it is within the specified
value range.
Reset the luminaire by
disconnecting the voltage from
the luminaire for
>
5 seconds
and then reconnecting.
In the event that the luminaire
switches off again, lower the
ambient temperature.
• Luminaire is defective
Return the luminaire for repair.
The luminaire only half
lights up or flashes
Defect in the
electrical circuit
• Defective driver
• Defective circuit
board
Reset the luminaire by
disconnecting the voltage from
the luminaire for
>
5 seconds
and then reconnecting.
If the problem persists, return
the luminaire for repair.
The luminaire emits
too little light when
compared to the other
luminaire(s)
Defect in the
electrical circuit
• Luminaire is defective Contact the installer and have
the wiring checked. If the
problem persists, return the
luminaire for repair.
Dimmer activated
Check the dimming
setting
Summary of Contents for HORTILED Top 2.0
Page 1: ...HORTILED Top 2 0 EN User and installation manual...
Page 2: ......
