10
MAN 9050619 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
Maintenance
•
After each use clean material out of hopper.
•
Rinse/dry inside and outside of the sweeper after each use.
•
Periodically check all fasteners for tightness and replace any damaged fasteners.
•
Check brushes for debris and keep brushes and brush shaft clean for optimal
performance.
•
Twice a year apply a few drops of light multipurpose oil to the brush shaft
bearings.
•
Annually clean and lightly lubricate all moving parts.
•
Every two years remove and clean gears and apply an even coat of light synthetic
grease.
•
Use a glossy enamel spray paint to touch up scratched or worn painted metal
surfaces.
•
Never exceed the hopper load capacity rating, as it will damage the bag.
•
Regularly grease axle and wheel bearing area or when needed.
Lubrication
The bearings in the sweeper have been pre-lubricated at the factory; however, it is
recommended that a few drops of light multipurpose oil should be added to the
brush shaft bearings twice a year. Also, every two years the wheels should be
removed to clean the gears. After cleaning the gears, apply an even coat of light
synthetic grease.
NOTE: To remove wheel, use a screwdriver to pop off hub cap, remove the lock nut and
washer.
Summary of Contents for 9050619
Page 2: ......
