2
MAN 9061374 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
GENERAL
lntended use
The shredder is designed solely for shredding/chipping
all kinds of newly cut tree
branches of diameter up to
8
cm.
Restrictions
You should not use the shredder for shred ding/chipping metal,
stones, plastics.
After the first hour's use check that the bolts of the blades and counter blade are
firmly fixed and that the gap between blades and counter blade is 0.5mm (half a
millimeter). Adjust in the slots if necessary and fix the bolts. (fig
.
2a, 2b)
Description of the Machine
The shredder is a machine for shredding/chipping newly cut wood
.
The rotor
has 2 blades each with a 30 cm width and is powered by a gasoline engine.
Transmission is through two parallel drive
belts.
The shredded wood or chips are discharged through the out put tube
by the centrifugal force of the rotor. Because of the angle of the blades and
the positioning of the counter blade branches are pulled inside the machine
automatically and no feeder belt is required.
(fig. 1).
