20
MAN 9062965 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: salg@p-lindberg.dk
Replacing the flails
IMPORTANT: Make sure that new flails have the same length and weight as the existing flails.
This will ensure well-balanced rotation.
1.
Remove bolt and nut.
2.
Remove the old flail.
3.
Fit the new flail and bolt.
4.
Secure with a nut.
Replacing the V-belt
WARNING
The V-belt system is spring-loaded, so exercise caution and avoid injury!
1.
Remove the belt guard.
2.
Loosen the V-belts by loosening the pulley securing bolt until the belt can be removed.
3.
Remove the old belt from the pulley.
4.
Fit a new belt.
5.
Tighten the pulley securing bolt.
6.
Replace the guards.
Storage
At the end of the season, it is highly recommended to prepare the flail mower for
winter storage as soon as possible.
1.
Start by carefully cleaning the flail mower. Dust and dirt absorb moisture and moisture
promotes the formation of rust.
2.
Be careful when cleaning with a high pressure cleaner. Never point the jet directly at
the bearings.
3.
Lubricate all lubrication points carefully after cleaning.
4.
Disconnect the PTO shaft, and lubricate it with grease on the profile tubes and in the
Cardan joints.
5.
Spray the mower with a layer of rustproofing oil. This is particularly important on all
parts polished from use.
6.
The flail mower must be stored indoors in a well-ventilated machinery shed to protect
the mower against the elements.
