20
MAN 9063092 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
Adjusting and replacing a V-belt:
CAUTION
Belt drive system under spring tension; use care to avoid bodily harm!
The Belt tension should be checked after the first 20 hours of use. And then every 40
hours of use.
1.
Tension on the belt can be adjusted with the belt tension bolt. Turn the bolt until
desired tension is achieved. When the belt has the correct tension the gearbox should
be adjusted so that the gearbox extension is running straight (parallel) with the flail
mower. Loosen bolts at the bottom of the gearbox and move gearbox until gearbox
extension is running straight.
2.
Excessive tension on the belt may lead to premature failure of belt and drive
components.
It is important that the V-belt runs straight and smoothly to ensure correct operation.
If a pulley is not operating correctly, it may be necessary to adjust the pulleys on the
side. This is also necessary when replacing a pulley.
1.
Remove the pulley shield to see and work on the
pulleys and V-belts.
2.
The pulleys are mounted on the shaft with a taper
lock constructed of a two-part conical bushing which
holds the pulley in place and makes it possible to
adjust the wheel on the side of the shaft at the
same time.
The taper lock is held together by 6 or 8 bolts
(depending on the model). The taper lock also has 3
(or 4) holes which are empty.
