24
MAN 9063092 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
Replacing flails
IMPORTANT: Make sure that new flails have the same length as the existing flails. This
will ensure balanced rotation.
1.
Remove bolt and nut.
2.
Remove the old flail.
3.
Install the new flail and bolt.
4.
Attach with nut.
Replacement of V-belt
WARNING
Belt drive system under spring tension; use care to avoid bodily harm!
1.
Remove the pulley shields.
2.
Loosen the belts by loosening the belt tension bolt until the belt can be removed.
3.
Remove the old belt.
4.
Install the new belt.
5.
Tighten the belt tension bolt.
6.
Re-install the pulley shields.
Storage
At the end of the season, it is highly recommended to prepare the mower for winter
storage as soon as possible.
1.
Start by carefully cleaning the mower. Dust and dirt absorb moisture and moisture
promotes the formation of rust.
2.
Be careful when cleaning with a pressure washer. Never point the jet directly at the
bearings.
3.
Lubricate all lubrication points carefully after cleaning.
4.
Disconnect the PTO shaft, and lubricate it with grease on the profile tubes and in the
Cardan joints.
5.
Spray the mower with a layer of rustproofing oil. This is particularly important on all
parts polished from use.
6.
The mower must be stored indoors in a well-ventilated machinery shed to protect the
mower against the elements.
