20
MAN 9058167 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70 21 26 26
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
Adjusting the pressure
The pressure adjustment control allows you to adjust the pressure in the system. To
avoid overspraying, always start with the lowest pressure setting and increase the
pressure to the minimum pressure that gives an acceptable spray pattern.
Selecting a pressure and nozzle
The chart below shows the recommended pressures for your material.
Material
Indoor paint
and indoor
and outdoor
enamel.
Outdoor
paint
Primer
Indoor
water-
based/latex
paint
Outdoor
water-
based/latex
paint
Spray
pressure
Low
High
High
High
High
Nozzle hole
0.28 mm
X
0.33 mm
X
X
X
X
0.38 mm
X
X
X
X
0.43 mm
X
X
X
0.48 mm*)
X
*) Max. nozzle hole compatible with this equipment.
Work techniques
Practise the basic spraying techniques on a piece of waste cardboard before you start
the job.
•
Hold the spray gun 30 cm from the surface and aim directly onto the surface. If you tilt
the gun up and down or from side to side it will give an uneven result.
Hi Spray
Low Spray
Prime / Clean
Roll
2900 psi
(200 bar, 20 MPa)
1500 psi
(103 bar, 10.3 MPa)
500 psi
(34.5 bar, 3.5 MPa)
