43
MAN 9058167 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70 21 26 26
DK-6600 Vejen
e-mail: salg@p-lindberg.dk
Problem
Cause
Solution
Select a nozzle with a wider
spray range.
Make sure you hold the
spray gun far enough away
from the surface.
The paint does not cover
well enough.
The paint layer is too thin.
Move the gun more slowly.
Select a nozzle with a bigger
hole.
Select a nozzle with a
narrower spray range.
Make sure you hold the
spray gun close enough to
the surface.
The spray pattern varies
significantly when spraying.
The pressure control switch
is worn causing pressure
variations.
Contact an authorised
workshop.
The gun cannot be released. The trigger is locked.
Turn the locking pin to
disengage it.
Paint is coming out of the
pressure control switch.
The pressure control switch
is worn.
Contact an authorised
workshop.
Paint is leaking out of the
return hose.
The equipment pressure is
too high.
Contact an authorised
workshop.
Paint is leaking down the
outside of the pump.
The pump gaskets are worn. Replace the gaskets.
The motor is warm and
running irregularly.
The motor automatically
turns off when overheating.
The equipment may be
The cooling fins may be
clogged or the equipment is
covered.
Keep the fins free of dirt and
foreign objects and ensure
adequate air circulation.
The extension cable is too
long or not thick enough.
Replace the extension cable.
The generator used is too
powerful.
Use a generator with the
correct power regulator.
