www.pstechnik.de
17
4.2.1.
Power Supply
Connector: Fischer 2 pin female
on camera back side (12 V - ) 24 V
WARNING:
When shooting with
more than 450 fps, use 24 V power
4.2.2.
On Board Battery Use
Connector: V-Mount or Anton-
Bauer Gold mount with additional
D-Tap female 12V (- 24 V)
4.3. Connecting electric equipment
There are several power outputs on the PS-Cam X35:
Voltage
Connector
Located on the PS-Cam X35
12 V
4-pin Lemo female
back side
12 V
Anton Bauer D-Tap female back side/top
24 V
3-pin Fischer female
right side
NOTE: When you run the PS-Cam X35 with a small battery there might be
not enough power to run the camera and several equipment.
For appropriate power cables refer to the accessory information (chapter
2.3. - 2.4.) or contact P+S Technik directly.
4.3.1.
Connecting the viewfinder/monitor
Connector: BNC female on camera
front side
Power: there are several power
outputs on the PS-Cam X35.
Therefore refer to Chapter 3 and 9
Signal: HD-SDI
NOTE: The PS-Cam X35 contains at its outputs „P“ signals instead of „PSF“
signals. It is not possible to switch between „P“ and „PSF“. However the PS-
Cam X35 is compatible to a wide range of recorders in HD.
