INTRODUCTION
>> A|3
OPERATOR‘S GUIDE BOOK
Precautions
Please read carefully.
MAX. 60° C -
Do not expose the camera or Con-
trol Unit to high temperatures.
In very hot setups, pre-
vent overheating of the camera by using styro and / or a fan
to get cool air close to the camera. The ventilation slot at the
righthand side of the camera is the „AIR IN“ slot! The actual
system temperature is shown in the status line in the „Camera
Control“ window. More than 60°C for El. Temp. or more than
65°C for Power Temp. endanger your equipment. This is es-
pecially very important when shooting top shots.
Avoid direct sun light.
Save Camera and Control Unit
from direct sun light, Tungsten or HMI light.
Avoid dust inside the Control Unit or Camera.
Prevent dust from coming inside through the fans.
Do not install additional software on the Control Unit.
If doing so, product guarantee will become void.
Do not connect the Control Unit to the internet.
If doing so, product guarantee will become void.
Be careful not to scratch the security glass in front of the
CMOS sensor
of the camera when you exchange the camera
mounts. Always cover the CMOS sensor with a cap, when no
lens is attached to the Camera.
Do not unplug any cable while Camera or Control Unit
are running!
Always turn off the camera before disconnec-
ting cables. If not this may cause break down your Windows
operating system.
When using Fiber Optic Cable
: Never bend, fold or crack
them nor step on them. Clean them regularly and treat the
connectors with care. Always use the connector caps when
not using the cables. Remember the inner core of this cable is
glass and very sensitive!
•
•
•
•
•
•
•
•
Summary of Contents for Weisscam HS-1
