Maintenance & Care
35
IMPORTANT -
Routine and accurate
maintenance is essential for maintaining
original machine safety and performance
levels.
Always stop the engine and unplug the spark
plug before doing any repairs or maintenance.
Only use original spare parts: The
use of non-original and/or incorrectly fitted
parts will jeopardize the safety of the machine,
may cause accidents or personal injuries for
which the Manufacturer is under no
circumstance liable or responsible.
1.
Wear strong protective gloves before
cleaning, maintaining or making adjustments
to the machine.
2.
You must remove grass and mud from the
machine to prevent it from drying. This will
cause problems the next time the machine is
used. For more information on cleaning, go to
page 43.
3.
Paint on internal chassis parts may start to
flake over time due to abrasive action of cut
grass. If this happens, you should touch-up
with rust-proof paint to prevent rusting that
could corrode the metal. You can also use a
light oil or silicone spray to prevent rust.
4.
If you need to access the lower part of the
machine, you must tilt the lawnmower with the
air filter facing up, following the relevant
instructions, making sure that the machine is
stable before performing any interventions.
5.
Make sure not to drip petrol onto the plastic
parts to prevent damaging them and remove
all traces of spilled petrol immediately. The
warranty will not cover damage to plastic
parts caused by petrol.
6.
It is highly recommended to change the
engine oil every 100 hours or 12 months. This
will ensure the machine will function properly
over time. The oil can be discharged at a
specialised servicing centre, or by using a
syringe to suction the oil out through the filler
spout, bearing in mind you may need to repeat
the operation several times in order to
completely empty the tank. Remember to
top-up with oil before using the machine
again.
7.
Lubricate the wheel bearings with a suitable
lubricant.
8.
It is necessary as part of routine
maintenance to adjust the OPC (Operator
Presence Control) cable tension to ensure the
lawnmower will start correctly.
If there is more than 10mm movement in the
OPC lever before the cable begins to move,
then the OPC cable will require adjustment.
CAUTION -
DO NOT
use a hose pipe or
pressure washer to clean the engine. Water
can damage the engine or contaminate the
fuel system.
Routine Maintenance
!
!
Summary of Contents for P4600SPE
Page 1: ...P1 Petrol Lawn Mower P4600SPE User Manual...
Page 48: ...48 Notes...
Page 49: ...Notes 49...
