12
PRESSURE WASHER IO
N
A
T
P
A
R
E
P
R
CONNECTING GARDEN HOSE TO PRESSURE WASHER
(Fig. 9)
1
.
Run water through the hose for a few seconds to flush any debris from
the hose.
2
.
Inspect the inlet screen and remove any debris.
3
.
Connect hose to water inlet and tighten by hand. There must be a
minimum of 10 feet of unrestricted hose between pressure washer
and faucet or shut off valve.
CONNECT HIGH PRESSURE HOSE TO PUMP
(Fig.9)
1
.
Attach the end of high pressure hose to the high pressure outlet
on pump.
2
.
Follow the same procedure with opposite end to attach high
pressure hose to spray wand.
3
.
Turn on water.
4
.
Purge the system’s pump of air by releasing the safety and
squeezing the trigger of the spray gun.
Fig. 9
Fig. 10
OPERATION
Before starting the pressure washer, make sure you have read and performed the steps in the “Pressure
Washer Preparation” section of this manual. If you are unsure about how to perform any of the steps in this
manual please contact your dealer.
DANGER: CARBON MONOXIDE.
Using a pressure washer indoors CAN KILL YOU IN MINUTES.
Pressure washer exhaust contains carbon monoxide (CO). .This is a poison gas you cannot see or smell. If you
can smell the pressure washer exhaust, you are breathing CO. Even if you cannot smell the exhaust, you may
be breathing CO.
NEVER use a pressure washer inside homes, garages, crawlspaces, or other partly enclosed areas. Deadly levels
of carbon monoxide can build up in these areas. Using a fan or opening windows and doors does NOT supply
enough fresh air.
ONLY use a pressure washer outside and far away from windows, doors, and vents.
