F o r m X X X X : R e v i s e d A u g u s t , 2 0 1 5
Page 5
2
Installation and Assembly
2.1
Mechanical
Looking at the control panel side, the stock passes through the straightener from left to right. Align the
straightener so that its pass centerline is in line with the pass centerline of the die, reel, and stock being fed.
Warning:
The fixed base must be lagged to the floor to prevent accidental tipping of the unit.
2.2
Electrical
The electrical power requirement of your Pallet Reel is clearly marked on the Control Box and on the tag
attached to the end of the power cord. Models requiring 220V power are shipped without a plug to allow the
receiver to install whatever 220V plug configuration is standard for their facility. Please ensure the Pallet Reel
is connected to the correct power source and that all wire, cable, etc. are installed in accordance with all
prevailing codes, Pallet Reel units, whether 100V or 220V, should be wired from power source fused for 15
amps
. Also on the schematic you will see “SPARE E-STOP”, this is for the customer to connect their e-stop connection in
conjunction with the palletizer.
3
Setup and Operation
3.1
Stock Guiding
Stock Guiding is adjusted on the inlet side of the stock straightener. Use a strip of the material to be
straightened for this adjustment. Position the strip between the two inlet roller guides (Refer Item #56). This is
done by: loosening the two screws (Refer Item #57); centering the strip of material in the straightener making
certain the strip is perpendicular to the straightening rollers; and sliding the guide rollers inward until there is
approximately .010" clearance between the strip and the guide roller on both edges of the strip.
CONTROL/DEVICE
DESCRIPTION
Power On/Error Reset button
Turns controller on; resets the AC drive.
Run/Stop button
Allows the reel to unwind by instruction from the
loop control; ceases movement of the reel.
Run Forward/Run Reverse button
Changes the feed direction of the straightener
Emergency Stop button
Shuts controller off.
Pallet Reel Jog Pendant
Jogs the table in either direction via the For (Forward)
and Rev (Reverse) buttons.
Straightener Jog Pendant
Jogs the straightener in either direction (Forward or
Reverse). Also selects the top or bottom straightener.
Summary of Contents for PR4,6/SS49
