OWNERS MANUAL
Congratulations on the purchase of your bathtub!
RIGONDA
Please read and follow all the instructions contained in this Owners Manual before installing your
bathtub. In addition, you should refer to these instructions during the life of your bathtub.
Instruction for bathtub installation
Only a qualified serviceman should perform the installation of your bathtub.
Preparation of area
The place under the tub must be in the same level as the floor.
All drain connections should fit in between bathtub and its legs (see the drawing).
The centre of drain is pointed in the drawing. Before assembling connections check the inlet of drainage (Ø 50
mm); it must be either in the same level or maximum 50 mm from the floor and not closer within a radius of 200
mm from the centre of bathtubs drain outlet (see the drawing).
In case the mixers are installed on the edge of the tub outlet pipes for hot and cold water with the ½” treads
must be arranged under the unit.
Electrical connection of the whirlpools
Grounding is required. Connect the tub to 230V, 50Hz wiring connection. Provide to each system proper electric
power, choose the right crosscut cable. Use for system separate 16A differential safety catch (electric current
loss max. 30 mA). Advised length for cable is 150 cm.
The distance between front panel and the floor has to be less than 20 mm.
Upon receipt, immediately inspect the bathtub to make sure the unit has shipped as ordered
and has arrived undamaged.
If a problem is discovered, call your PAA dealer immediately.
Handling damages are not covered under warranty.
pic.
b
max 20mm
pic.
a
C
D
position C2
C1
C2
C3
