HANDLELOK STRAP PIVOT REPOSITION INSTRUCTIONS
P
ERFORMANCE
A
DVANTAGE
C
OMPANY 12-2017
For additional assistance call 888-514-0083 between 8AM-5PM EST or email: info@pactoolmounts.com
INS-1004
FIGURE 2D
The elastomer lock strap can be
repositioned to a higher pivot position to
allow the securing of objects which are
oversized.
Please read, understand and follow these
instructions. Failure to properly assemble may
result in personal injury and/or property damage.
STEP 1
–
Remove Strap
Remove the pivot pin to free the strap. You may drive it through the bracket by tapping it with a
punch pin or by grasping the exposed end with a pliers and pulling it through. See figures 2A & 2B
STEP 2
–
Replace Strap and Insert Pivot Pin
FIGURE 2A
(Punch Through Method)
FIGURE 2B
(Grip Method)
Place the strap in line with the pivot pin hole and carefully insert the pin through the bracket
and strap. Allow approximately ¼” of pin to extend on each side. The correct orientation of the strap is
where the circular mark is visible on the underside of strap after assembly. See figures 2C& 2D
ORIENTATION MARK
FIGURE 2C
Contact PAC customer service for product warranty information.
www.pactoolmounts.com
Verify that the pin is secure after insertion.
