Page 2
Page 3
PAC
®
| 866-931-8021 | support@pac-audio.com
©2016 Pacific Accessory Corporation
www.pac-audio.com
Rev. 113016
Pacific Accessory Corporation
PAC is an AAMP power brand
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
Disassembly of the factory radio control assembly (cont.)
2.7 - Remove the 12 Phillips head screws
shown below.
2.8 - Be sure to keep the screws separated
as they will be used during the assembly
stage later.
2.9 - After the screws have been removed,
remove the HVAC knobs by pulling them
from the front of the faceplate being careful
not to bend the contacts on either end of the
contact swiper on the backside of each of
the knobs.
2.10 - Look inside the opening where the
knobs were removed. Remove the 2 Phillips
screws shown below. Do this for both
openings
.
2.11 - Remove the 2 support brackets and
keep handy as they will be used in the next
step.
Assembly of the PAC HVAC control assembly
3.2 - Secure the 2 support brackets to
the circuit board using the same screws
removed from Disassembly step # 9. The
screws will pass through the board and
thread into the brackets via the holes defined
below. Be sure that the alignment tabs are
seated properly.
3.1 - Secure the 2 support brackets to the
PAC HVAC control assembly using 4 of the
same screws shown in disassembly step #
7. Do this to the back of each side. Be sure
that the alignment tabs are seated properly
in the circuit board to the front.
3.3 - Position the knobs in the proper opening
so that the buttons are straight and insert
them into the opening. With
VERY LITTLE
force rotate them slightly left and right while
pushing them towards the PCB. Once the
alignment tabs are lined up they should click
and lock into place. Use extra caution as the
contacts could bend while rotating.
