Pacbrake Inline Mount, Installation Manual

INLINE MOUNT Exhaust Brakes

I N S T A L L A T I O N   M A N U A L  

-   L 2 0 3 1

P G .   2

Getting Started

Thank you and congratulations on your purchase of a Pacbrake Inline Mount

®

 exhaust brake kit.

Before starting, be sure you have attained the proper brake, mounting kit and control group for your vehicle.  
Below is a sample of all the parts needed for installation.

*Some models require back pressure adjustment.
For these models a gauge kit is required.
PN C10600.

Verify the vehicles exhaust pipe size is correct for the adapt-
ers supplied. 

NOTE:  The adapters are expanded to slide over the 
existing exhaust pipe. Pacbrake adapters are avail-
able for all standard exhaust pipe sizes.  Compare 
the exhaust pipe OD against the adapter I.D. before 
cutting the exhaust pipe.

1

With the exhaust brake on the bench, loosely attach the ex-
haust pipe adapters provided, and make a measurement to 
determine the length of vehicle exhaust pipe to be removed. 
The adapters are expanded to slide over the existing exhaust 
pipe—consider this in your measurement

2

Select a location that has sufficient clearance for installation 
and servicing of the exhaust brake. This location should be 
as close to the turbocharger as possible and away from dirt 
and road spray. Keep in mind that Exhaust Brakes subjected 
to road spray will shorten the life and require a Remote Cyl-
inder Breather Kit PN# C11020. Transfer the brake/adapter 
measurement to this location and mark the exhaust pipe. 
Remove the exhaust pipe and cut the pre-marked section.

NOTE: In some cases, the cutting and welding of ex-
haust systems can be done without removing the pipe 
sections from the vehicle.