Pacbrake Inline Mount, Installation Manual

INLINE MOUNT Exhaust Brakes

I N S T A L L A T I O N   M A N U A L  

-   L 2 0 3 1

P G .   3

3

Clamp exhaust brake and exhaust system in place and tack 
weld prior to final welding. Weld the adapters to the sections 
of pipe, being careful to maintain the proper length and 
angles that exist. Welding can be done on the outside or the 
inside of the adapter, but it must be leak free.

NOTE: Clamped joints that exist between the brake 
and the engine must also be welded at this time to 
ensure the joint cannot separate or leak under pres-
sure.

4

If removed, reinstall the front section of pipe on the engine. 
Torque turbo clamp to engine manufacturers specification. 
Center brake and tighten clamp on the exhaust brake pres-
sure side.  Install the rear section of pipe and loosely clamp. 
Check alignment of all sections and joints and torque “V” 
clamps to 10 FT.LBS.

5

Select a location to mount the 12V compressor assembly. 
Mounting can be in any position. The location should be free 
of heat and contamination and must provide the compres-
sor a good electrical ground by attaching the compressor 
grounding wire to a good ground source.