STEP FOUR: Installing Dispenser Unit
(CONTINUED)
Nut M4
(3 pcs)
Screw M4
(3 pcs)
E.
Reinstall the Reservoir
Tank and close the
Dispenser. Find the on/off
switch located on the lower
right side of the Dispenser
and turn it on. Plug in the
A/C converter into the
nearest outlet. (For
portable use, slide open
the bottom right side panel
of the Dispenser while
opened and install four C
batteries.)
F.
Place hand under the
Dispenser, and a 0.5oz
dose with UV light will be
automatically dispensed.
USER INSTRUCTIONS
STEP FOUR: Installing Dispenser Unit
STEP THREE: Pole/Stand Assemly
Nut M4
(3 pcs)
Screw M4
(3 pcs)
A.
Locate the unit
assembled in Steps 1-3,
Dispenser, three M4
screws, three M4 Nuts, and
U-shaped Key.
B.
Take the U-shaped key
and open the Dispenser by
inserting the key into the
two holes on top of it.
Press down until the
Dispenser opens in half.
C.
Gently remove the
Reservoir Tank.
D.
With the Dispenser
open, hold it to the Back
Plate and line up the holes
on the backside of the
Dispenser to the front of
the Back Plate. Insert the
three M4 screws into the
holes to secure the
Dispenser and apply the
M4 nuts to the end of each
screw. Tighten the screws.
CONTINUED
8
7
