- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
25
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
NANO 1000T / FEMTO 1500
Polishing Head
5.7.2 Direction and speed controller (manual)
1. To change direction of the wheel:
-Press FWD (clockwise) or REV (counter clockwise),
LED will light
2. To change the speed of the wheel:
Select one of the low, medium or high preset speed
buttons and use the Up and Down arrows to fine tune
speed if required
457 MANUAL Hand Polishing Mode (NANO ONLY)
1.
Install working wheel and attach grinding papers / polishing cloths.
2.
Power on the machine in the back and set the mode, speed, and time (if required).
3.
Rotate water spout over working wheel. During sample preparation adjust water flow by
turning water control knob as required. Note: Initial operation of water valve may contain
air in the lines. Turn water on slowly to purge air from system.
4.
Press RUN/STOP start and stop the machine in the manual mode.
To use the NANO polishing without the FEMTO head, turn off the power to the FEMTO head
using the main power switch on the back of the FEMTO head.
Swing the FEMTO head out of the way.
5.7.1 Grinding / polishing by hand