-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
▲
I
NSTRUCTION
M
ANUAL
MEGA
-
T300A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1
-
520
-
882
-
6598 Fax +1
-
520
-
882
-
6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
23
5.0 Maintenance
5.1 Introduction
5.2 Cleaning outside cabinet
The recommended maintenance for the
MEGA
-
T300A
includes the following:
1.
Use an anti
-
corrosion cutting fluid such as the MAXCUT 2 cutting fluid. It is recommended
that the cutting fluid be changed every 50 cuts or weekly for maximum effectiveness.
2.
Rinse and dry the table and vises after use.
3.
When the cutter is not in use keep the hood OPEN to prevent humidity and corrosion build
-
up inside the cutting chamber.
4.
If cutter will not be used for an extended period of time, coat the table and vises with a
water displacement oil such as WD
-
40.
5.
Use only recommended abrasive blades to minimize overheating the bearings and motor.
Do not exceed the recommend amp rating of the motor.
6.
Grease the appropriate fittings periodically (minimally after every 200 cuts or every other
month, whichever occurs first).
7.
Immediately replace any broken or damaged parts.
Note: corrosion is considered a maintenance issue and not a warranty issue
The cabinet and front shield should be cleaned occasionally with a moistened cloth. Do not
use any chemicals or cleaning abrasives. We recommend an anti
-
condensation gel be used
on the front panel.
