HS 300 Pre-Heater Operations Manual
Page 3 of 5
e. Place a Support Rail over the top of the HS 300 and make sure the
far end of the Support Rail is placed over the back edge of the HS
300. See Figure 3.
Support Rails
Power Inlet
Temperature
Control Knob
Power Switch
Figure 3.
f. Tighten the black knob on the Support Rail to secure rail to HS 300.
g. To adjust the Support Rail, loosen the black knob and slide the
Support Rails from side to side to match the width of the PCB.
h. The Holder Pins can be adjusted by twisting the pins a quarter turn
and sliding them back to front in their grooves on the Support Rails
until properly positioned.
CAUTION: The Holder Pins will become hot during normal
operation. Use a tool, gloves, or turn unit off and allow to cool
before adjusting Holder Pins.
i. The PCB can be slid into position. See Figure 4.
Figure 4.
