Chapter 4
Verifying the i3822V and iPSU Installations
31
Enabling the ETHERNET port
The ETHERNET port is disabled by default. This port is used only if the subscriber has
Cat 5 wiring throughout the home that is terminated on the side of the home. It
supports other Ethernet devices, such as switches or hubs.
To enable the ETHERNET port:
1. Open a browser and enter http://gateway.2wire.net or http://172.17.0.1 as the
URL.
2. On the
Settings
tab, click the
LAN
tab, and then click
Wired Interfaces
.
3. Click the
Auto MDIX
check box to enable the ETHERNET port on the i3822V.
4. Click
Save
.
COAX
•
Solid green
. A device is connected (such as a set-top
box).
•
Flashing green
. There is inbound activity associated with
the COAX port. The flickering of the light is synchronized
to the actual data traffic.
•
Red
. A device failed to be authenticated or successfully
connected.
LINE 1 and LINE 2
•
Solid green
. The associated voice line has been
registered with the network and is ready for use.
•
Flashing green
. A phone is in use on the associated
voice line.
These two indicators mirror LINE 1
and
LINE 2
indicators
on the i38HG.
ETHERNET
•
Solid green
. A device (such as a computer) is connected
to the ETHERNET port.
•
Flashing green
. There is inbound activity from devices
connected to the ETHERNET port. The flickering of the
light is synchronized to the actual data traffic.
BATTERY
•
Solid green
. The AC power is connected and healthy.
•
Flashing red
. The backup battery is being used for
power.
Indicators
Description
