©2012 PACE Inc., Southern Pines North Carolina All Rights Reserved
Page 8 of 20
The Tip & Tool Stand can be mounted to the power source. If the system will be placed on the
workbench, this is recommended. If the power supply is to be mounted under the workbench or shelf,
the Tip & Tool Stand should not be mounted to the power source.
To attach the stand to the power source:
1. Insert the 2 large hex head Mounting Screws (head first) into the
lower “T” slot on the side of the power source case as shown.
2. Place the Tip & Tool Stand beside the power source. Insert ends
of the 2 Mounting Screws into the 2 Tip & Tool Stand mounting
holes as shown.
3. Install a Thumb Nut onto the end of each Mounting Screw and
tighten Thumb Nuts.
4. Place the handpiece into its Tip & Tool Stand.
Handpiece Connection (All Models)
Connect the handpiece connector plug into the Power Receptacle in the
following manner.
1. Align guide on connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
Air Supply Connection (For ST 65 Only)
The ST 65 system utilizes an integral air venturi system to provide air pressure and vacuum for any
connected PACE handpiece requiring air/vacuum. Your in-house air supply must be connected to the
system power source.
1. Connect air supply to the ST 65’s air inlet on the back of the system.
2. Install the Connector (with Small, Flexible Air Hose) onto the Air
Hose Fitting (or metric adapter) finger tight. Using an appropriate
wrench, tighten the Connector an additional 1/4 turn.
DO NOT
over
tighten.
3. Connect the free end of a the air hose to your air supply using the
appropriate fittings.
NOTE
IntelliHeat systems are designed for use with PACE handpieces with
blue power connectors. Older “black” connector handpieces can be
used by purchasing the optional adapter (P/N 6993-0278-P1).
IMPORTANT
The system must be connected to a clean, dry, and filtered,
compressed air supply regulated to 5.48 Bar (80 P.S.I.).
NOTE
The Air Hose Fitting on the rear of the ST 65 requires a 1/8-27 NPT threaded airline fitting (to be supplied by
customer).
DO NOT
over tighten connections. Damage to the system could occur if excessive torque is applied
to the Air Hose Fitting, Connector, or Metric adapter (G1/8 ISO thread, Part Number 1259-0081).
